D3X RS
D3X RS Operator’s Manual
10
3.2. Installing, removing, and operating the annular cutter
Install the arbor as described before, wear protective gloves, and then insert the
proper pilot pin into the annular cutter (
1
, Fig. 4). Use a clean and dry cloth to wipe
the cutter. Next, place the cutter into the arbor (
2
) in such a way to align the flats
3
with the set screws
4
, and then use the 5 mm hex wrench to tighten both set screws.
To remove the cutter, loosen the screws
4
using the 5 mm hex wrench.
Fig. 4.
Installing the annular cutter
1
2
4
3
