Steelmate PTS600MM, Руководство пользователя

Страница: 7 / 16

11
Troubleshooting
After installation, the display doesn't work
a) Are all wires connected properly?
b) Is the vehicle's ignition ON?
Damaged sensor detected
a) Are all sensors plugged into the ECU correctly
and tightly?
b) Is the sensor wire broken?
c) Is the sensor covered by mud or snow?
d) Is the sensor damaged?
False warning
a) Are all sensors plugged into the ECU in the
correct position tightly?
b) Does any sensor detect the ground?
c) Does rubber ring in the sensor come out (14D
sensor)?
Warning sound is too low or too high
a) Press the Volume button to adjust the volume
to a suitable level.
If the problem persists, please follow these
steps
a) For consumer contact your dealer or nearby
service centre.
b) For installer or dealer
1) Test the sensors with certified ECU by using
a flat wooden board.
2) Replace the ECU and recheck the system.
3) Plug the certified sensors into the ECU and
recheck.
4) Email your question to us and we will reply
ASAP.
Attention Sensor maintenance
Do not wash the sensor with squirt gun or
swab them forcibly.
Please wash car with low-pressure water.
Please melt the ice with water when the
sensors are covered by ice.
Please clean the sensors with cloth or low-
pressure water when the sensors are covered
by mud or snow.
10
False detection may occur in the following
situations:
*
After installation, please fully test the system
before use.
*
Heavy rain, dirty or damaged sensors may result
in false alarm occasionally.
*
Ensure that the self-test procedure is completed
and all sensors are functioning before reversing.