HEAVY DUTY FRONT BUMPER
2011-14 CHEVY SILVERADO 25-3500
Page 2 of 4
7/20/15 (DP)
5.
Next, slide the passenger side Frame Bracket and tow hook over the end of the frame. Attach the
Bracket to the frame with the included (3) 12mm x 150mm Hex Bolts, (6) 12mm Flat Washers, (3)
12mm Lock Washers and (3) 12mm Hex Nuts,
(Figures 4 & 6)
. Insert (1) 12mm Bolt Plate into and
down through the hole in the bottom of the frame and out through the Bracket. Secure with (1) 12mm
Flat Washer, (1) 12mm Lock Washer and (1) 12mm Hex Nut,
(Figures 4 & 6)
. Do not fully tighten
hardware at this time.
6.
Repeat
Steps 4 & 5
to install the driver side Mounting Bracket and tow hook.
7.
With assistance, position the Bumper Assembly up to and over the Brackets. Temporarily support the
weight of the Bumper.
WARNING
: To avoid possible injury or damage to the vehicle, do not proceed
until the Bumper is fully and safely supported.
8.
Line up the (3) holes in the passenger side mounting plate on the inside of the Bumper with the (3) slots
in the Frame Bracket. Attach the Bumper to the Bracket with the included (3) 12mm x 50mm Hex Bolts,
(6) 12mm Flat Washers, (3) 12mm Lock Washers and (3) 12mm Hex Nuts,
(Figures 5 & 6)
. Do not
fully tighten hardware at this time.
Repeat this Step to attach the driver side mounting plate to the
Frame Bracket.
9.
Level and adjust the bumper and fully tighten all hardware to 65-70ft-lbs.
10. Models with fog lights
:
a.
Slide the light into place through the opening in the bumper. Push the attaching posts into the
tabs on the bumper,
(Figure 7)
. Repeat this Step to install remaining light.
b.
Reattach the factory wiring harness to both lights.
11.
Use the included (2) push-in Plastic Nuts to attach the front license plate, (if required), to the (2) holes
in the front Bumper,
(Figure 8)
.
12.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment
, wax this product after installing. Regular waxing is recommended to add a
protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could
damage the finish. Mild soap may be used to clean the Heavy Duty Front Bumper assembly.
WARNING!
Do not remove bumper bolts
unless the bumper is properly supported on
blocks or stands or the bumper may fall.
(Fig 2) Remove tow hooks
(Fig 1) Remove rubber deflector between
back of bumper and bottom of radiator.
Pictured from below-under front bumper.
Front
