FORTIS REAR BUMPER
2014-19 TUNDRA
Page 1 of 8
6/6/19 (AL)
PARTS LIST:
1 Fortis Rear Bumper
8 12mm x 37mm x 3mm Flat Washers
1 Driver/Left Frame Bracket
4 12mm Nylon Lock Nuts
1 Passenger/Right Frame Bracket
2 8mm x 25mm Hex Bolts
1 Driver/Left Support Bracket
4 8mm x 16mm x 1.6mm
1 Passenger/Right Support Bracket
2 8mm Lock Washers
4 Sensor Plugs
2 8mm Hex Nuts
1 Cover Kit
6 6mm x 30mm Button Head Bolts
8 4mm x 10mm Button Head Bolts
12 6mm x 12mm x 1.6mm Flat Washers
2 License Plate Plugs
6 6mm Lock Washers
2 Plastic BSS Covers
6 6mm Hex Nuts
1 Driver/Left BSS Bracket
6 5mm x 16mm Button Head Bolts
1 Passenger/Right BSS Bracket
6 5mm Lock Washers
8 14-1.5mm x 55mm Fine Thread Hex Bolts
6 5mm x 10mm x 1mm Flat Washers
16 14mm x 28mm x 2.5mm Flat Washers
1 5mm Allen Wrench
8 14mm Lock Washers
1 3mm Allen Wrench
8 14mm Fine Thread Hex Nuts
1 2.5mm Allen Wrench
4 12mm x 45mm Hex Bolts
PROCEDURE:
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION. BUMPER IS HEAVY, ASSISTANCE IS
RECOMMENDED TO AVOID POSSIBLE INJURY OR DAMAGE TO THE VEHICLE.
1.
Begin at the rear of the vehicle. Remove the license plate from the bumper. Unplug the wiring harness
leading to the rear bumper
(Figure 1)
. Move all wiring harnesses away from bumper.
2. Determine if vehicle is equipped with a factory receiver hitch
Models without Factory Receiver Hitch
a.
Place blocks or jack stands under the bumper to support it during factory bolt removal. Once the
bumper has been safely supported, remove the factory hardware attaching the bumper to the
frame,
(Figure 2)
. Remove Bumper from the frame.
b.
Select the Driver/Left Support Bracket. Attach the bracket to the bottom of the frame with (2)
factory bolts,
(Figure 7 & 8)
.
(2) Plastic Plugs
for License Plate
(4) Sensor Plugs
Driver/Left
Frame Bracket
Driver/Left
Support Bracket
Passenger/Right
Support Bracket
Passenger/Right
Frame Bracket
Driver/Left
BSS Bracket
Passenger/Right
BSS Bracket
Passenger/Right
BSS Cover
Driver/Left
BSS Cover
