Page 3 of 4
939503209 Rev B
4.
secure legs to worksurface.
Place screwdriver into access
hole over scr ews and drive
scr ews until tight. Leave one
of the legs loose until modesty
panel is attached. This will be
tightened later .
5.
attach modesty panel to legs
Slide the hooks on the ends of
the modesty panel into the slots
on both legs (they fit tightly in
the slots) and push the modesty
panel down until it touches the
worksurface.
6.
attach modesty panel to
worksur face. Attach the modesty
panel to the underside of the
worksurface using the scr ews as
shown. Return to step 5 to
tighten the two scr ews in the leg
that were left loose.
7.
attach wire covers to legs
Snap the wir e covers into the leg
frames (if not alr eady attached),
by placing the edge of the wir e
covers into the groove in the legs
and gently pr essing the covers
until they snap into place.
8.
flip the desk over. Use two
people to flip the desk over.
Adjust the glides to compensate
for uneven floors.
That’s it!
4
5
6
7
