Page 2 of 4
939503209 Rev B
1.
unpack the components
Unpack the parts and lay them out on a carpeted surface
(to avoid scratches). Make sure you have all the items
shown below.
2.
lay worksurface down
Lay the desk worksurface upside down with the holes facing
up. Insert four (4) screws into the pilot holes on the ends of
the worksurface and screw half-way in.
modesty panel
end legs
table top
wire covers
END legs (legs with 28” foot
and 1 outside and 1 inside wire
cover) are used for all outside
leg positions on 30” deep
worksurfaces.
MID legs (legs with 23” foot
and 2 inside wire covers) are
used for all internal leg positions,
example: desks with bridges
attached. (Note: stand alone
desks do not need a mid leg).
RETURN legs (legs with 23”
foot and 1 outside and 1 inside
wire cover) are used for all
outside leg positions on 24”
worksurfaces.
ATTACHMENT SLOT
3.
attach legs to desk worksurface
Position legs over top of screws and slide leg toward
front of desk to engage screws into slots.
end leg - 28”
mid leg - 23”
return leg - 23”
