Page 7 of 8
939549946 Rev G
8.
Connect power cord and switch cord to control box (8a).
Connect power cord from control box to wall outlet (8b). Install a
zip-tie or velcro strap at top of column to retain the cord assembly
(8c).
9.
This should always be installed on the right hand side
of the worksurface.
NOTE: Push button stick-on controller installation is
shown here. Remove paper backing from controller
before installation.
10.
Cycle the leg to its maximum height making sure
the cords reach through the full travel requirement.
If leg fails to operate, press the 'down' button until the
worksurface comes to a stop at the lowest position.
Release the 'down' button. Press and hold the 'down'
button for approximately 10 seconds while the table
synchronizes itself. The surface will lower itself
approximately 5mm, then rise approximately 5mm and
finally settle back to its lowest position.
NOTE: It might be necessary to repeat the synchronization
process more than once.
8b
8c
9
CONTROL BOX
POWER CORD
Push Button Stick-On
Controller
®
POWER CORD AND
SWITCH CORD
8a
CONTROL BOX