Page 4 of 4
939502116 Rev C
Push Bar Installation
NOTE: You will need to cut the holes in the fabric. We
recommend a hole punch tool that is 3/8" diameter.
(McMaster-Carr, Osborne, etc.)
1.
Mark the two (2) hole locations as shown.
2.
Verify location by using a pin, find the center of
the treaded inserts that are pre-installed in the frame
under the fabric at the two (2) marks made in step 1.
3.
Now that you know where the center of the
threaded inserts are, push and rotate the hole punch
tool in the center of the verified hole location to cut
through the fabric down to the steel. Remove the cut
piece of fabric.
4.
Install the screws, lock washers, collars &
washers with an allen wrench as shown.
5.
Place the push bar over the
collar/washer assembly and install
the set screws as shown.
PIN
HOLE
PUNCH
TOOL
1
20-1/4"
6”
2
3
4
5
LOCK WASHER
SCREW
COLLAR
WASHER
Mitra Recliner
(Back View)
Mineral Recliner
(Back View)
1-1/2”
6”
1-1/2”
20-1/4”
