Page 2 of 4
939502116 Rev C
Drainage Bag Installation
NOTE: You will need to cut holes in the fabric.
We recommend a hole punch tool that is 3/8"
diameter. (McMaster-Carr, Osborne, etc.)
1.
Mark the two (2) hole locations as shown.
FOR MINERAL ONLY:
2.
Verify location by using a pin, find the
center of the treaded inserts that are
pre-installed in the frame under the fabric at the
two (2) marks made in step 1.
3.
Now that you know where the center of the
threaded inserts are, push and rotate the hole
punch tool in the center of the verified hole
location to cut through the fabric down to the
wood. DO NOT DAMAGE WOOD! Remove the
cut piece of fabric.
4.
Install drainage bag bracket with two (2) flat
head screws (provided) with phillips
screwdriver.
OR MITRA ONLY:
2.
There are no inserts behind the fabric. Push
and rotate the hole punch tool in the center
(same as step 3 above) and remove the cut
piece of fabric. (This is done so the installer will
not stretch the fabric when installing the
screws.)
3.
Install drainage bag bracket with two (2) flat
head wood screws (provided) with phillips
screwdriver into the wood side frame.
2
1
3
4
Mitra Recliner
MINERAL Recliner
5/8"
1-1/4"
17-1/16"
12-5/16"
PIN
HOLE
PUNCH
TOOL
FLAT HEAD
SCREW
DRAINAGE
BAG BRACKET
