Installation and assembly
FrameOne Plus Manual -en- 2017
Page 13 of 29
Installation and assembly
Safety instructions
WARNING
Danger of injury and damage!
When lifting on the desktop or attached components, the fastening screws
may tear.
Transport or move the desk only by grabbing the base frame.
Checking the delivery contents
After unpacking, the product must be checked immediately for transport damage and for completeness. Any
damage must be reported to the manufacturer as soon as possible.
Disposing of the packaging material
The packaging includes the following:
Outer packaging made of cardboard.
Polyethylene (PE) foil.
Bubble wrap made of polyethylene (PE).
Edge protectors made of cardboard or polyethylene (PE).
Corner protectors made of polyethylene (PE).
These materials are recyclable. When the product is assembled by Steelcase or an authorised installer, the
packaging is disposed of by the manufacturer. If you install yourself, please ensure sorted separation and
return to the recycling cycle.
Installing the desk
Installation and use of the product requires detailed planning. For this purpose, Steelcase offers its own
planning department.
The partially assembled components of the
FrameOne Plus
desk are usually delivered by specialist dealers
or directly from the manufacturer.
The installation location must meet the following requirements:
Sufficient carrying capacity of the floor.
Horizontal storage surface.
Assembling the desk
Steelcase recommends assembly by a specialist dealer or an assembly company.
Height compensation
To compensate for uneven ground, you can raise each foot by up to 1.0 cm with an adjusting screw.
For a desk that has already been assembled: before levelling, remove any objects from the desk top.
