![Steelcase Flex Height-Adjustable Desk Скачать руководство пользователя страница 5](http://html1.mh-extra.com/html/steelcase/flex-height-adjustable-desk/flex-height-adjustable-desk_user-manual_1369338005.webp)
Active Touch Controller
STORE HEIGHT INTO MEMORY
To set into memory the desired height for either seated or standing work, use
the two memory position buttons.
•
Lift
up
or press
down
on the controller to reach the desired desk height.
•
Press and hold the memory position button,
1
or
2
, for one second until the
number 1 or 2 flashes and the light guide fills.
•
To save an additional height, repeat this sequence using the
1
or
2
button.
•
To clear all stored memory positions, press and hold the
1
and
2
buttons
simultaneously, for one second, until the display flashes “PRESET CLEAR”
and the light guide fills.
•
With the control box in standby mode, the desk can lose power without
affecting the Synchronization of the lifting columns. However, if the control
box is still active and not in standby mode, a power loss will require that the
lifting columns be re-synchronized.
•
Power fluctuations and brownouts can also cause the need for
resynchronization.
Note:
The control box does not reset (initialize) by being unplugged and
plugged back in. Refer to the power cycle procedure below.
POWER CYCLE THE CONTROL BOX:
•
In the unlikely event an error occurs, and the desk is unresponsive, disconnect
power to the desk for at least 10 seconds to reset the control box.
•
Reconnect power to the desk and synchronize the lifting columns as
outlined below.
MEMORY RESET OF CONTROLLER
In the unlikely event that an error occurs, the controller may need to be reset to
the factory settings.
If using the Active Touch Controller
•
Press hold the
1
,
2
and buttons simultaneously for eight seconds.
•
Continue to press and hold as the display cycles past “ADJUST HEIGHT”
and the actual desk height until the display flashes “MEMORY RESET” and
the light guide fills.
•
Synchronize the lifting columns as outlined below.
If using the 4 Preset Programmable Controller
•
Press and hold the
up-down
buttons simultaneously for five seconds to reset
the control box.
•
Synchronize the lifting columns as outlined below.