Page 7 of 8
939503022 Rev D
Installation of SMCL-1W & SMCL-6W
Clip
1.
Place service module on desk top.
2.
Place flange of clip up against underside of
desk top. Using both thumbs, snap clip over
edge.
3.
Align holes in clip with holes in service module.
Fasten service module to desk with (4) #8-1/2 Pan
Hd screws. Balance overhang of desk top equally
on both sides, tighten one clip slightly and then
the other until both are secure. Install (1) #10 x 1/2
Rh Ph screw through clip and into underside of top.
Task Light Wire Channel Installation
1.
When installing a task light under a service
module, route the light cord through the wire
grommet as shown. Remove protective paper
from two-way tape. Route the light cord through
the wire windows in the service module and desk
end panel. Place wire channel tabs into wire
window hole, making sure the channel is straight
and press into place. Note dotted lines.
Remove
plastic
grommets
SMCL-1W
Clip used to attach any service
module to desks with 1-1/4"
thick wood tops without reveal.
Drilling required.
Package Contains:
1 - Service Module
2 - SMCL- 1W Clips
4 - Screws, #8-1/2 Pan Hd
2 - Screws, #10 x 3/4 Rh Ph
SMCL-6W
Clip used to attach any service
module to 2300 series desks.
Drilling required.
Package Contains:
1 - Service Module
2 - SMCL- 6W Clips
4 - Screws, #8-1/2 Pan Hd
2 - Screws, #10 x 3/4 Fh Ph
Window in
Service Module
Clip bracket
Press
thumbs
here
Grommet
Protective Paper
Two-Way Tape
Wire Channel
Wire Window
Hole (Service
Module)
Wire Window
Hole (Desk)
Wire Channel Tabs
