Page 8 of 8
939500519 Rev B
®
Attaching Legs to Worksurfaces
Note the orientation
of the leg relative to
the worksurface.
Attaching Worksurface Reinforcement Brace
1.
For worksurfaces without legs, measure 6" in from the
front edge of the worksurface on its bottom side. For
worksurfaces with legs, measure 7-1/2" from the front
edge. Use the support brace as a straight edge.
2.
Center the 57" brace on the worksurface bottom, left to
right, and align with the pencil mark. Use the brace as a
template for pilot holes.
3.
Fasten the support brace to worksurface bottom using
the screws provided.
6"
7-1/2"
