Wrong
Correct
.015 Min.
1
2
3
4
RETAINER CLIPS
ARE ATTACHED TO ALL
WIDTHS OF POWER KITS.
NOTE:
Match Receptacle
Back Color to Block Color
for proper keying.
NOTE:
THE QUALIFIED ELECTRICIAN CAN
CUT THE POWER IN HARNESS TO LENGTH
(WIRE END), MAKING SURE THE UL LABEL
IS INSTALLED ON HARNESS.
NOTE:
Page 6 of 10
939504633 Rev Y
Standard Power In Feed - Floor
1.
Install the floor power infeed into the receptacle
opening of the power block.
2.
Route base power-in harness through the backside
of the base trim knockout before hard wiring.
3.
Hardwire the harness to junction box.
4.
Attach jumper cover.
WARNING
Risk of Fire or Electric Shock
Base trim must engage in plastic retainer
clips on receptacle blocks to ensure proper
alignment. Receptacles should protrude
from base trim when correctly installed.
WARNING
Risk of Fire or Electric Shock
Do not connect to source of supply until
fully installed in furniture. All sources of
power supply must be disconnected prior
to any servicing or installation.
