®
Page 3 of 12
78540 Rev A
3.
Move the lower storage unit into the approximate
location, the front about 24" from the beam.
4.
Hook the tether brackets into the beam’s top cap
side channel by angling the worksurface upward in the
front until the brackets enter the channel (4a), and
then rotating the worksurface back to level, resting on
the storage unit (4b).
NOTE: Worksurfaces can be adjusted laterally, while
tethered to top cap (for 1" gap applications) by angling
their fronts up enough to allow the tether brackets to
slide.
DO NOT slide worksurfaces with storage units
attached.
5.
Adjust the storage unit glides to close the gap
between the worksurface and the storage unit, and to
level the storage unit and the worksurface.
6.
Once the worksurface and storage unit is properly
aligned, secure the front of the storage unit to the
underside of the worksurface, with two (2) 1" long
screws through the storage unit front cross brace.
3
24"
6
6
4b
4a
