Steel City TITANIUM 50-550, Руководство пользователя

Страница: 12 / 40

◊ SANDING BELT TENSION
The tension of the sanding belt is controlled by an air
cylinder. Turn the belt tension knob to put or remove
tension on the belt.
When the machine is not in use, release the belt tension
to avoid belt fatigue.
NOTE: the machine will not start if there is
no tension on the belt
or if a limit switch is depressed.
Page 12
◊ TABLE MOVEMENT
The height of the table can be manually adjusted by
mean of the handwheel ( F ) located below the table,
or by using the digital keyboard in the control panel:
Motorized movement: Press Table Up or Table Down ( G )
key once for moving the table in increments of 0.005’’
(0.1mm)
Keyboard ( H ): to enter desired value
Digital display ( I ): Shows the entered value
Table Start key ( J ): Moves the table to the entered value
Table Stop key ( K ): Stops table movement
Metric/Imperial unit key ( L ): Press and hold the key for
10 seconds to switch between metric and imperial unit.
Press and hold the key for 3 seconds to calibrate the
display at the current board thickness.
ADJUSTMENTS
◊ SANDING BELT TRACKING
The sanding belt tracking is the side movement of the
sanding belt while oscillating. The travel should be
equal on both ways and remain inside its normal track,
or the machine will stop.
Tracking was set at the factory, but might require
adjustment for example, after replacing sandpaper.
Tracking depends on the stream of air in the air fork
gap, on oscillation timing and on oscillation speed .
Adequate stream of air is required through the air flow
controller;
keep the holes clear, as if the jet of air is weak, the belt
will track away from the controller and into the limit
switch on the opposite end of the roller.
F
I
H
L
J
K
G