18
MOTOR AND BLOWER
TO BASE ASSEMBLY
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.
1.
Place motor and blower assembly and base on
their side with intake port pointing towards base.
Fig. 3-1
2.
Align the four holes, two shown (A) on the top of
both side supports (B) with four holes in the motor
and blower assembly (C). See figure 3-1.
3.
Place a 5/16” lock washer onto a 5/16-18 x 5/8” hex
head screw and insert the screw through the side
support and thread screw into tapped hole in the
motor and blower assembly. Do not completely
tighten.
4.
Repeat this process for the remaining three holes;
tighten securely.
SUPPORT ASSEMBLY
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.
1.
Place the support (A) inside the two side supports
(B).
MAKE CERTAIN THE SUPPORT IS
ATTACHED TO THE SIDE SUPPORTS CLOSEST
TO THE MOTOR
. See figure 4-1.
2.
Align the four holes (C) three shown, in the support
with the four holes in the side supports.
3.
Insert a 5/16-18 x 5/8” hex head screw with a 5/16”
lock washer through the side support and support.
4.
Place a 5/16-18 flange hex nut onto the 5/16-18 x
5/8” hex head screw. Do not completely tighten.
5.
Repeat Steps 3 and 4 for remaining three holes
and tighten securely.
Fig. 4-1
B
C
A
B
B
A
C
(Blower housing not shown for clarity.)
WARNING
!
WARNING
!
Содержание 65110
