17
ASSEMBLY
1.
DO NOT
assemble the Dust Collector until you are
sure the tool
IS NOT
plugged in.
2.
DO NOT
assemble the Dust Collector until you are
sure the power switch is in the “OFF” position.
3.
For your own safety,
DO NOT
connect the machine
to the power source until the machine is completely
assembled and you read and understand the entire
Owner’s Manual.
SWIVEL CASTER TO
BASE ASSEMBLY
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.
Fig. 1-1
1.
Insert bolt (A) from swivel caster through one of the
four holes in the base (B), three are not shown. See
figure 1-1.
2.
Place 3/8-16 hex nut and 3/8” lock washer (C) onto
bolt of swivel caster and tighten.
3.
Repeat Steps 1, 2 and 3 for the remaining three
swivel caster assemblies.
1.
Place the base (A) in an upright position.
See figure 2-1.
2.
Align two holes in the wider end of side support (B)
with two holes (C) in the base.
3.
Insert a 5/16-18 x 5/8” hex head screw with 5/16”
lock washer through each of the two holes in the
side support and base.
4.
Place a 5/16-18 flange hex nut onto each screw
and tighten securely.
Fig. 2-1
Fig. 2-2
5.
Repeat Steps 1, 2, 3, and 4 to assemble the
second side support. See figure 2-2.
C
A
B
SIDE SUPPORT ASSEMBLY
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.
B
A
C
WARNING
!
WARNING
!
Содержание 65110
