Steel City 50126SC, Руководство пользователя

Страница: 23 / 34

23
UPPER BEARING ADJUSTMENT
NOTICE: Make certain that you have followed all of the
steps in the SETTING BLADE TENSION section in the
ADJUSTMENTS section of this manual prior to starting
this section.
1. Loosen adjust nut (A) and slide thrust bearing (B)
until it is within .003 of the saw blade. This is
equivalent to about the thickness of a dollar bill.
Once the thrust bearing is set, retighten adjust nut
SEE FIG. 20.
Fig.20
A
B
2. The block guide (E) should be positioned within
1/32” of the blade. If an adjustment is necessary,
loosen thumbscrew (C) and adjust knob (D) until the
is within 1/32” of the blade. Use this
process for the left and right s. Thumb
screw(F) in FIG.20 is used to hold the blocks in
place. Loosen and move if necessary to achieve
1/32" to the blade, and then tighten.
3. Once s and thrust bearing are set, make
certain that all thumbscrews are re-tightened.
block guide
block guide
block guide
E
C
D
LOWER BEARING ADJUSTMENT
1. Loosen (A) and slide thrust bearing(B)
until it is within .003 of the saw blade. Again, this is
about the thickness of a dollar bill. Once the thrust
bearing is set, retighten
.
adjust nut
adjust nut SEE FIG. 21.
Fig.21
2. The block guides (E) should be positioned within
1/32” of the saw blade. If an adjustment is neces-
sary, loosen thumbscrew (C) and adjust nuts (D)
until each
is within 1/32” of the blade.
Each (E) is controlled separately by
the M6x10mm Hex soc set (F) with 3mm
allen wrench directly.
3. Once and thrust bearing are set,
make certain that all thumbscrews and
are re-tightened.
block guide
block guide
screw
block guides
adjust nuts
F
B
A
F
E
C
D