Steel City 50126SC, Руководство пользователя

Страница: 20 / 34

ADJUSTMENT
TABLE TILT
The table on your bandsaw is designed to tilt up to 45
degrees to the right and up to 3 degrees to the left. To
tilt the table:
1. Loosen both lock knobs (A) on the underside of the
Table. SEE FIG. 12.
2. Tilt the table to the right noted that the scale
(B) shows the angle of the table.
3. Re-tighten lock knobs when desired angle is
achieved.
NOTE:
SEE FIG. 13.
This positive stop bolt (C) used to adjust table to
match the blade at 90 degrees.
Fig.13
20
SETTING BLADE TENSION
The blade tension is set by using the blade tension knob.
It
be set prior to initial operation as it plays a vital
role in setup of other features of the band-saw. It should
also be checked when the blade is replaced, and from
time to time as the blade will stretch after prolonged use.
Keep in mind that putting too much or too little tension
can cause either blade break-age (too much pressure) or
poor cutting results (too little pressure).
MUST
1. Set the blade tension by rotating the knob (A).
Turning the knob clockwise increases the tension
while turning the handwheel counterclockwise
decreases the tension.
SEE FIG.14
Fig.14
Fig.12
B
A
A
A