Steel City 35990C, Руководство пользователя

Страница: 22 / 56

22
RIVING KNIFE / SPLITTER
COMPONENTS ASSEMBLY
BLADE ASSEMBLY
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
WARNING
!
NOTE: Remove the table insert (Table insert are gripped
by four magnets on the table).
Fig. 20
C
Fig. 22
Fig. 22
INSTALLING AND REMOVING
THE RIVING KNIFE / SPLITTER
To Install:
1. Loosen the knob by pulling upwards (C), Line up the
riving knife/splitter in the proper direction to the
mounting bracket (B).
SEE FIG. 21
2. Push the Riving Knife/ Splitter all the way down into the
mounting bracket, make sure the location pin is
properly locked in the hole of the Riving Knife/ Splitter.
(The location hole is on the button side of the Riving
Knife/ Splitter ).
3. Tighten the fasting knob by lowering down (C).
SEE FIG. 22
To Remove:
1. Loosen the fasten knob (C). SEE FIG. 22
2. Remove the Riving Knife/ splitter out of mounting
bracket
(B). SEE FIG. 22
NOTE: Make sure blade or arbor is at the highest position
before adding or removing the riving Knife/ Splitter.
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
WARNING
!
Fig. 23
C
B
C
M
K
L
J
Z
L