Steel City 20-302, Руководство пользователя

Страница: 14 / 20

Page 14
DUsT CoLLeCTIon
Using this machine without dust collection may
cause premature wear, but also represent a
health hazard for the user and for the other
people in the workshop.
sTArTInG orDer:
start: start the dust collector, then the saw.
stop: stop the saw, then the dust collector.
The saw is equipped with a dust port located at the bottom
of the saw casing and provides a Ø4’’ connection.
MAInTenAnCe
◊ CLeAnInG AnD LUBrICATIon
-All bearings are sealed and life lubricated and do not
require additional maintenance, except replacement
eventually.
-Blow dust away and clean the saw frequently,
especially the blade guide blocks and bearings
to prevent build up of pitch, resin, etc.
When accumulation of dirt resists to normal dusting:
-Clean with the use of a soft solvent (do not use
acetone or lacquer thinner)
-Lubricate using lubricant for dusty environment
Threaded parts and mobile parts should be inspected,
cleaned and lubricated regularly to prevent
malfunctioning.
◊ DrIVe BeLT rePLACeMenT
1. Release blade tension.
2. Remove the blade.
3. Remove the nut and washer from the center of the
wheel.
Untighten the nut by turning in clockwise direction.
◊ CLeAnInG BrUsH
A cleaning brush is installed to prevent pitch and saw-
dust build up on the lower wheel. Verify that the brush
keeps the lower wheel tire clean at all times. It will wear
over time and will not clean as well, you must then re-
place it.
4. Remove the wheel. You now have access to the belt.
5. Loosen the motor base bolts to slide the motor
and release belt tension.
6. Remove the belt and install the new one.
7. Do the above steps in reverse order. Make all
adjustments related to blade change.
Make sure the switch is in the off position and
the machine is unplugged.
wArnInG
!
wArnInG
!