GENERAL OPERATION
NOTE: Be sure that Water Tank has been filled and all
desired accessories are connected before following
these steps.
1.
For first-time use, remove protective plastic cover that is
shipped on electrical plug. Plug power cord into a
convenient electrical outlet.
2.
Turn Steam Control Dial clockwise from “OFF” position to
desired steam setting (FIGURE 9). Power Indicator Light
will immediately illuminate to indicate that unit is powered
on and heating.
NOTE: Steam settings are broken down by intensity
(“LOW” & “HIGH”) as well as function (“MOP/FABRIC”
& “HANDHELD CLEANER”). Refer to Page 13 for more
information about selecting steam settings.
3.
After approximately 30 seconds, you will hear a buzzing
sound as unit begins to emit steam.
4.
Direct Steam Nozzle (with any connected accessories)
towards surface you wish to steam. Refer to
Steam
Mopping
section below, as well as
Fabric Steaming
and
Steam Cleaning
sections on Page 12, for further details.
CAUTION: Always be sure that Steam Nozzle and any
accessories are pointed in a safe direction (away from
yourself, other people, pets and plants) when steaming.
STEAM MOPPING
NOTE: It is recommended to sweep or vacuum floors before mopping.
•
Make sure Extension Pole, Mop Head and a Microfiber Pad are all properly connected. Refer to Pages
6 & 7 for details.
•
Follow
General
operating instructions above to begin steaming. For best results, set unit within
“MOP/FABRIC” range as indicated on Steam Control Dial.
NOTE: Only “LOW” setting is recommended for hardwood floors.
•
Mop using a steady back-and-forth motion over the floor, working your way backwards in order to avoid
walking over the freshly mopped area.
NOTE: To avoid warping or damage caused by heat and moisture, do not use on unsealed hardwood
or unglazed ceramic surfaces. Steam may remove the sheen from some floors that have been
treated with wax.
•
To effectively kill bacteria and microorganisms, repeatedly mop a single small area (approximately 3’ x 3’ for
best results) for at least 2 minutes.
•
The Microfiber Pad will absorb moisture during mopping. However, depending on floor surface and steam
intensity setting, some residual moisture may be left behind. In this case, it is recommended to allow floor
time to air-dry. A fan may be directed towards mopped area to facilitate drying.
•
Due to large size of the Mop Head, it may have difficulty completely cleaning certain types of floors (such as
ceramic tile) that include crevices of grouting. To more thoroughly clean floor grout, it is recommended to
use 3-in-1 Steam Mop in steam cleaning mode. Refer to
Steam Cleaning
section on Page 12 for details.
FIGURE 9
ENGLISH | 11
