www.stealthtronic.com | [email protected]
user manual
Glite PRO
Sleep function (it will temporarily disable the
module GSM) It has 2 parameters which must
be set, SLPINT and PWRINT sets time for
connecting back to GSM network.
SLP
0 – OFF
1 – ON
This function will turn on SLEEP mode and prolong the battery life of
the module. It will wake up for a speci
fi
ed time set by SLPINT0-360
minutes, in case there is SNDSENS or MOVESENS the module call
speci
fi
ed number even when ASLEEP. The amount for which ONLINE
ON GSM is set by PWRINT in minutes.
Setting interval for being asleep. You will not be
able to reach the unit or send commands to it.
SLPINT
1-360 minutes
When the unit is asleep, it will not be able to wake itself up even by
calling on it. It will only be awake if there is noise or movement and the
parameters are set correctly. After the cycle of minutes the module will
connect to GSM for PWRTINT speci
fi
ed time
Awake interval for connecting back to GSM
PWRINT
1-360 minutes
Interval for which the unit will go online to GSM
GSM Sleep function:
Advanced commands:
Please be advised, those commands are only for experience users. By bad usage, you can turn off the GSM signal device and make it either only responsive
to NOISE(SNDSENS) or MOVEMENT(MOVESENS) or you can also shut the device completely off.
MODE SLP1 is used to save battery. We recommend using commands
MOVESENS, SNSDSENS,SLPINT and PWRINT before you activate SLP command.
NOTE:
These advanced functions are to be used for special occasions. For example, when sweeping of spaces would be scheduled, you can deactivate the
module and (S MOVESENS) so the module will be “o
ffl
ine” therefore undetectable.
Another function would be to set a schedule for when you know there is noise which you don’t want to listen to and waste battery life. Let’s say a car
ride, you can then send to the module SLPINT60,PWRINT5, SNDSENS0, MOVESENS0. – that will translate to the module being o
ffl
ine for 60 minutes,
after that it will wake up for 5 minutes.
PRESET MODES:
Make sure to turn off diodes before (LEDMSK0)
MODE1 = PWRINT2, SLPINT15
MODE3 = PWRINT2, SLPINT60
MODE2 = PWRINT2, SLPINT30
MODE4 = PWRINT2, SLPINT300
You can activate each mode by sending MODE1 or MODE2 to the
device. Please be advised that you have to send your NOISE(SND-
SENS) or MOVEMENT(MOVESENS) beforehand.