Flap Disc
With the flap disc (accessory), curved surfaces and profiles
can be worked. Flap discs have a considerably higher
service life, lower noise levels and lower sanding
temperatures than conventional sanding sheets.
Cutting Metal
For cutting metal, always work with the protection
guard for cutting 7.
When cutting, work with moderate feed, adapted to the
material being cut. Do not exert pressure onto the cutting
disc, tilt or oscillate the machine.
Do not reduce the speed of running down cutting discs by
applying sideward pressure.
The machine must always work in
an up-grinding motion. Otherwise,
the danger exists of it being
pushed uncontrolled out of the cut.
When cutting profiles and square
bar, it is best to start at the smallest
cross section.
The machine may be used only
for dry cutting/grinding.
For cutting stone, it is best to use a diamond cutting disc. As
a safety measure against jamming, the cutting guide with
dust extraction protection guard must be used.
Operate the machine only with dust extraction and
additionally wear a dust protection mask. The vacuum
cleaner must be approved for the extraction of masonry
dust.
STAYER
provides suitable vacuum cleaners and
suction casing.
Switch on the machine and place
the front part of the cutting guide
on the workpiece.
Slide the machine with moderate
feed, adapted to the material to be
worked.
5. Maintenance instructions
5.1. Cleaning, maintaining, lubricating,
sharpening
Before any work on the machine itself, pull the mains
plug.
For safe and proper working, always keep the machine
and ventilation slots clean.
In extreme working conditions, conductive dust can
accumulate in the interior of the machine when
working with metal. The protective insulation of the
machine can be degraded. The use of a stationary
extraction system is recommended in such cases as
well as frequently blowing out the ventilation slots and
installing a residual current device (RCD).
Please store and handle the accessory(-ies) carefully.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should be
carried out by an after-sales service centre for
STAYER
power tools.
5.2. Repair service
The technical service will provide you advice regarding
questions you may have on the repair and maintenance of
your product as well as on spare parts. You may also obtain
exploded views and information on spare parts on the
internet under:
Our team of technical advisors will be glad to guide you
regarding acquisition, application and adjustment of
products and accessories.
5.3. Guarantee
5.4. Disposal
It is compulsory to subject electric tools, accessories and
packaging to a recovery process that respect the
environment.
For EU countries only:
Do not throw away electric tools!
In accordance with European Directive
2002/96/EC on unserviceable electric and
electronic apparatus, after its transposition into
national law, they must be collected separately
to subject them to ecologic recycling.
The right to amendment is reserved.
6. Legal Regulations
6.1. Technical features
The values given are valid for nominal voltages [U] 230/240
V ~ 50/60 Hz - 110/120 V ~ 60Hz. For lower voltage and
models for specific countries, these values can vary. Please
observe the article number on the type plate of your
machine. The trade names of the individual machines may
vary.
We reserve the right to change related to
technical advance.
Guarantee card
Included in the documentation that accompanies this
equipment, you should find the warranty card. You should
fill out the card completely and return to vendor with a copy
of purchasing receipt or invoice and you should receive a
receipt.
Note: If you cannot find the warranty card within the
documentation, you must ask for it through your
supplier.
The warranty is limited only to manufacturing defects and
expire if pieces have been removed or manipulated or
repaired other than the manufacturer.
21
21
ENGLISH
