-4-
4. Part Names and Functions
⑪
AC inlet: Plug the attached power cable.
【
Front Panel
】
①
Power display LED :
The LED flashes when power is on.
The LED flashes for about 30 seconds
after power is on. When the heater is
enough heated, the LED is changed to
the steady light.
【
Rear Panel
】
⑥
XLR connector pinout drawing:
1: SHIELD
2: HOT
3: COLD
To use Pin-3 HOT audio player device, use your
conversion adaptor or cable.
⑤
XLR input terminals:
Connect your audio device with
XLR output terminals.
⑦
SOURCE selector switch: Select XLR or RCA input. For the factory default, the unit is set to “RCA”.
Caution! This unit cannot switch input signals. Unplug an unused cable.
⑧
RCA input terminals: Connect an audio player device with RCA output terminal.
⑨
PARALLEL OUT terminals
(
Throughout terminals
)
:
Using PARALLEL OUT terminals, signals from an audio player device are directly outputted.
Use PARALLEL OUT terminals to connect other amplifier or driver unit.
Unplug the cable when a device connected to PARALLEL OUT terminals is not used.
※
In rare cases, when a device connected to PARALLEL OUT terminals is not operating, playback
signals may be distorted. In this case, turn on or unplug a device connected to PARALLEL OUT
terminals.
⑩
GND: Ground terminal:
In case that hum noises are emitted, be sure to make the ground connection.
Connect a grounding wire to a ground terminal or metal parts
(
bolts etc.
)
of other devices, or an outlet
grounding terminal.
Types, materials, thickness and colors of grounding wires do not matter.
The top cover has ventilation holes.
Do not put objects on the top cover
.
④
①
OFF
ON
②
Power switch
:
Push the button to turn on. Push the button
once again to turn off.
If power is turned off and immediately turned
on after the heater is heated, LED flashes.
②
③
⑦
⑧ ⑨ ⑩
⑤
⑪
⑥
Voltage in your country
④
Volume knob:
The concentric dual knob can be turned simultaneously.
To adjust left and right audio balance, turn one section of the knob independently.
The front section is for L-CH and the back section is for R-CH.
③
Sockets for PRO type earspeaker:
Plug a 5-pin type earspeaker.
