●
Before connecting, make sure that the power switch is set to OFF.
(
Refer to page 4
)
●
Connect to the output terminal
(
RCA pin jack or XLR connecter
)
of the audio player device.
For RCA connection, use the attached cable.
For XLA connection, use your cable.
Both XLR input and RCA input are connectable, but input signals cannot be switched.
Be sure to disconnect the unused cable.
●
XLR connector pinout drawing indicates that No.2 is HOT.
To use Pin-3 HOT audio player device, use your conversion adaptor or cable.
●
Plug the attached power cable into AC inlet on the rear panel and insert the plug into the outlet on the
wall.
●
Plug the earspeakers to the earspeaker sockets on the front panel.
●
Push the power button. The orange LED
①
flashes. Wait for about 30 seconds until the vacuum tube
heater is enough heated. When the unit is ready to be used, the LED is changed to the steady light.
●
Turn the volume knob slowly to the right to adjust to the best volume.
Turn the front section of the concentric dual knob to adjust the left channel.
Turn the back section of the knob to adjust the right channel.
Adjust the left/right volume balance with this knob.
●
If the volume is not enough using a “REC OUT” terminal of a pre-amplifier or integrated amplifier,
connect to a PRE OUT terminal.
●
Another way to connect: To connect to a audio player device with a mini stereo jack.
Your stereo mini plug to RCA plug conversion cable or conversion plug can be connected to the unit.
Set the volume of your audio player device to the normal position. And adjust the volume of SRM-500T.
2.
for use
-3-
3. Precautions for use
●
The unit contains a high voltage circuitry. It is dangerous. Do not remove the top cover
and the bottom cover. Do not use the unit in wet, dusty, high temperature humid places.
●
The unit emits heat. Do not block the ventilation holes on the top and bottom of the unit.
Install the unit in a well ventilated place.
●
To install on shelves, make sure that there is at least 5cm space between the unit and a
shelf board.
●
Do not install the unit vertically.
●
Because of low distortion, the volume of the earspeakers is likely to be too high.
Listening sound at high volume for a long time is not good for your health.
●
If the unit is installed near a main amplifier, hum noises may be emitted.
●
The power cable is exclusive for SRM-500T. Use only the attached power cable.
●
Unplug the power cable from an outlet when not in use for a long time.
