STAUFF SWG-WG, Руководство по эксплуатации

Страница: 15 / 36

15
6 Warranty
©Walter Stauffenberg GmbH & Co. KG
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
6 Warranty
Please refer to the latest "General Terms and Conditions" for the scope of the
warranty.
The warranty does not cover faults caused by e.g.
– Normal wear,
– Improper handling,
– Failure to observe the operating manual,
– Failure to observe the safety precautions,
– Use for other than the intended purpose, or
– Transport damage.
Warranty entitlement shall no longer be valid if modifications, changes or service
and repair work is carried out by unauthorised persons or without the knowledge
of the manufacturer. Invalidation of warranty entitlement shall also render the
declaration of conformity invalid. The CE marking shall be declared invalid by
the manufacturer.
We expressly point out that only spare parts and accessories or components
approved by us may be used. The same applies likewise to installed units from
our sub-suppliers.
6.1 Disclaimer
STAUFF provides SWG, devices and accessories with its production range for the
use of attaching STAUFF Clamps according to DIN3015-1.
The STAUFF production range SWG, devices and accessories uses short-term stud
welding with drawn-arc (procedure 784).
The executing welding personnel bears the responsibility for strength and quality of
welding joints.
Please note especially chapter 5.1.
Welding personnel and coordination as well as further framework conditions must
meet the requirements according to ISO 14555.
Beside the common examination agreement between the welding joint creator and
the purchaser of the product there are the simplified or the recommended production
control tests according to ISO 14555 to be executed.