Staufenbiel Yak 11, Инструкция по эксплуатации

Страница: 19 / 32

19
www.staufenbiel-shop.com
info@modellhobby.de
+49 40 30061950
EN
To make assembly of the wings on the fuselage
easier, we recommend using 3 patch cables
(10 cm). These always remain plugged into
the receiver; the cables are then disconnected
directly on the wing.
22
Route all cables neatly in the fuselage and wire
the receiver. The flight battery must also be se-
cured with adhesive tape on the underside next
to the Velcro strap.
Our tests have revealed that the model harmo-
nises very well with the 3X Wing Control gyro-
scope from Dymond. The gyroscope sensitivities
can be set to the “12 o’clock position” for all 3
axes here, without the model soaring in flight.
23
In the last step, connect the servo-cables of the
wing to the patch cables described above.
Then screw the wing to the fuselage (4x).
24
The centre of gravity is measured on the top of
the wing in the case of a low-wing aircraft; the
model must be in the back position for this.
The centre of gravity is located after the lea-
ding edge at 110-115 mm, measuring point as
shown in the figure.
25