Statpower Portawattz 400, Руководство по установке и эксплуатации

Страница: 12 / 36

8
1. Attach the ring type connector marked with red to the positive
(+) DC terminal on the PORTAWATTZ 400 and attach the
ring connector marked with black to the negative (-) DC
terminal.
CAUTION! A reverse polarity connection (positive to negative)
may damage the PORTAWATTZ 400. Damage caused by a
reverse polarity connection is not covered under warranty.
2. Tighten the nut on each DC terminal by hand until it is snug.
Do not over tighten.
3. Insert the plug of this cable into the 12-Volt outlet and switch
the unit ON. See Section 9 if the PORTAWATTZ 400 does
not operate properly after being connected.
4. When the PORTAWATTZ 400 is not in use, unplug it from
the 12-Volt outlet to prevent slight discharge of the battery.
5.3 Using the DC Cable-Clips
By directly connecting the PORTAWATTZ 400 to a 12-Volt battery
with the DC Cable-Clips , you can operate products with power
requirements up to 400 Watts continuous. If you want to
permanently connect the PORTAWATTZ 400 to a battery, refer to
Section 5.4.
1. Follow steps 1 and 2 above (Section 5.2) to attach the ring
type connectors.
2. Attach the black negative clip to the negative (-) battery
terminal
3. Attach the red positive clip to the positive (+) battery terminal.
Make sure both clips are securely connected to the battery
terminals, as a loose connection will cause excessive voltage
drop and may cause the cables to overheat resulting in
equipment damage or fire.
4. Switch the PORTAWATTZ 400 ON. See Section 9 if the
PORTAWATTZ 400 does not operate properly after being
connected.
5. When the PORTAWATTZ 400 is not in use, disconnect the
DC Cable-Clips from the battery. This will prevent slight
discharge of the battery.