INSTALLATION
Before Locating the Fixing Brackets
The unit should be placed on a stable, smooth surface (use the packaging). Do not apply
force onto the controls protruding from the hob. Fix the hob on the work surface by screwing
4 brackets on the bottom of the hob (see picture) after installation.
Adjust the bracket position to suit for different work surface’s thickness.
Cautions
1. The ceramic cooker hob must be installed by qualified personnel or technicians.
Please never conduct the operation by yourself.
2. The ceramic cooker hob shall not be mounted to cooling equipment, dishwashers
and rotary dryers.
3. The ceramic cooker hob shall be installed so that better heat radiation can be ensured
to enhance it’s reliability.
4. The wall and induced heating zone above the work surface shall withstand heat.
5. To avoid any damage, the sandwich layer and adhesive must be resistant to heat
6. A steam cleaner is not to be used
7. This ceramic can be connected to a supply only with system independence no more
than 0.427ohm. In case necessary, please consult your supply authority for system
independence information.
Connecting the Hob to the Mains Power Supply
The power supply should be connected in compliance with the relevant standard, or a
single-pole circuit breaker the method of connection is shown below-
1. If the cable is damaged or needs replacing, this should be done by an authorised
service agent.
2. If the appliance is being connected directly to the mains supply, an Omni polar
circuit breaker must be installed with a gap of 3mm between the contacts.
3. The installer must ensure that the correct electrical connection has been made and
it complies with safety regulations.
4. The cable must not be bent or compressed
5. The cable must be checked regularly and only replaced by a properly qualified person.