STAS AgroStar Alu, Инструкция по эксплуатации

Страница: 26 / 40

STAS - Instructions for use moving floor
26
D. SYSTEM DESCRIPTIONS
In order to use the moving bulkhead with floor sheet correctly, proceed as follows:
• Detach the rubber bands which keep the moving bulkhead in position.
• Detach the floor sheet from the moving bulkhead and spread it out over the loading floor as far as possible.
• Ensure the track rails for the moving bulkhead on both sides of the trailer are not obstructed along the full length
of the trailer.
• Check whether the left and right hand end stops of the moving bulkhead are fitted in the track rails.
• Once the trailer has been loaded, check whether sufficient material has been poured onto the floor sheet. This
to ensure that the floor sheet is pressed sufficiently against the loading floor and to ensure that the load does
not end up underneath the floor sheet or behind the moving bulkhead.
Figure 8.1.b. – Floor sheet detail (left) and fastening of moving bulkhead (right)
At the end of the unloading procedure, the floor sheet will be hanging out the trailer. If the
trailer is fitted with a hydraulically operated top swinging door, ensure that this door cannot
be operated when the floor sheet is being re-laid in the trailer or when the operator is in the
load space. This to prevent the risk of trapping. To this end, the storage area for the control
unit for the top swinging door should be locked prior to entering the area concerned.
• After unloading, the moving bulkhead with floor sheet should be pushed back against the front of the trailer and be
fastened correctly.
The detachable funnel may be used to unload cereals into a unloading well. The funnel is stored underneath the trailer
and behind the side guard.
8.2. DETACHABLE FUNNEL
Figure 8.2.a. – Funnel behind side guard
Figure 8.2.b. – Locking pin (left) and fixing rod (right)
Figure 8.2.c. – Raised side guard
In order to install the funnel, proceed as follows:
• Remove the locking pin and fixing rod on both sides of the side guard and raise the side guard.
• Replace the fixing rods and locking pins to ensure the side guard stays up.
• Pull the locking pin out of the funnel and slide the funnel out of its storage position.