STARWADERS Portable Solar System Model
v1-20718
Page
8
The Parts of the PSSM
Follow these instructions to assemble the model:
•
Build the stand by inserting the legs into the
base.
•
Insert the lower upright into the neck on top of
the base. Align the hole near the bottom end of
the lower upright with the hole in the neck.
Insert the pin into the hole to lock the lower
upright in place. This allows the built model to
be picked up and moved if necessary, without
sliding off the base and legs. It also ensures
that the upright does not slide all the way through the base onto the
ground.
•
Fit the upper upright into the top of the lower upright.
•
Fit the axis into the top of the upper upright.
NOTE: Normally use the Tilted Mode axis. For use where the frame is
horizontal, use the Horizontal Mode axis.
•
Fit the neck of the hub onto the axis with the side where the screws are
facing forwards.
Note that the height of the frame can be made lower for young children
by only using one of the uprights.
•
Insert the arms into the sleeves around the hub. Ensure that the slits in
the arms are facing towards the front.
