Instruction Manual
10
Unit Stack
This function allows the user to use one single remote control to command up to 16
Video Matrix Switch units.
Setting the Remote Controlling ID on the system
1. Power off the Video Matrix Switch.
2. Press and hold 1 and 2 at the same time.
3. Power on the Video Matrix Switch.
4. Release 1 and 2.
5. Select any one of the 1 through 8 remote control buttons, 4 for example. This sets
the current Video Matrix Switch remote controlling ID to 4.
6. To control the Video Matrix Switch, press Shift + 4 on the remote control. The
unit with the remote controlling ID of 4 will beep twice, and its LED will blink
continuously.
7. Repeat Steps 1 through 5 if there is more than one Video Matrix Switch unit being
cascaded. Note that each unit must be assigned a different remote controlling ID,
otherwise each will receive remote control commands simultaneously.
Optimize the Video Signal Strength
The optimal video signal strength can be adjusted to correspond to the length and
quality of the DVI cables being used. Each monitor has two different video strength
settings.
For example, were the user to change the video strength setting of Source 2 for
Monitor 3, the necessary steps would be:
1. Switch Monitor 3 to Source 2 (Refer to Basic Operations for details).
2. Press the desired port (ie. 3).
3. Press and hold Option.
4. Press 4 to turn on the video signal strength setting mode for Monitor 3.
