Instruction Manual
4
8. Connect the USB 3.0 cable from the enclosure to the host computer system.
NOTE:
A USB 2.0 cable can be used in place of the USB 3.0 cable, however the
enclosure will only run at USB 2.0 speeds.
9. Select the RAID mode you wish to use with the slide switch on the rear of the
enclosure and press the RESET button. See “
RAID Modes
” for more information.
10. Once the mode is set, the drive(s) will be detected by the operating system.
NOTE:
If the enclosure has not been accessed for more than 5 minutes, the fan will
turn off. Also, if the USB cable is not connected, or the host computer system goes into
sleep/hibernation mode, the hard drive and fan will spin down.
Driver Installation
No driver installation is required for the supported operating systems, as this hard
drive dock is natively supported, so the drivers are already installed.
Содержание SAT3520U3R
Страница 5: ...Instruction Manual 2 Front View Rear View...