2
USB 3.0 micro-B
connector
Power/Activity
LED
Installation
WARNING:
Hard drives require careful handling, especially when being
transported. If you are not careful with your hard disk, lost data may
result. Always handle your hard drive and storage device with caution.
Hardware Installation
Slide both the top and bottom covers of the enclosure off to reveal the
1.
plastic frame of the enclosure.
Place a 2.5” SATA hard drive into the tray by angling the hard drive
2.
towards the SATA hard drive connector on the circuit board. Slide the
hard drive into the connector and then lower the opposite end into the
tray.
Using the provided screws, fasten the hard drive to the frame of the
3.
enclosure from the bottom side.
Place both the top and bottom covers back onto the enclosure, making
4.
sure to line up the screw holes on the covers with the screw holes on
the side of the enclosure. Use the provided screws to fasten the covers
to the frame.