Instruction manual
3
Install a drive
Warning!
Drives should be handled carefully, especially when you transport them. If
you’re not careful with your drives, you may experience lost or corrupted data. Make
sure that you’re properly grounded by wearing an anti-static strap when you install
any computer component. If an anti-static strap isn’t available, touch a large, grounded
metal surface for several seconds to discharge any built-up static electricity.
1. Remove the protective sleeve from the case by grasping a corner of the sleeve and
peeling it off of the protective casing.
2. Open the latch on the protective casing.
3. Use the provided hex key to remove the six screws from the protective casing.
4. Pull the two sections of the protective casing apart.
5. Gently slide your drive into the corresponding SATA drive connectors in one half of
the protective casing. The connector on your drive is keyed so that it only fits one
way.
6. If you are installing a 7 mm drive, place the foam drive pad between the end of the
drive and the protective casing.
7. Place the two sides of the protective casing together and close the latch.
8. Insert the six screws into the protective casing and use the hex key to tighten the
screws.
9. Replace the protective sleeve over the protective casing.
