StarTech.com PCI511WB, Инструкция по эксплуатации

Страница: 17 / 22

15
Appendix C: Setting Up an Infrastructure Network
An Infrastructure network consists of both Wired and Wireless elements joined by a
Wireless Access Point. Follow the instructions below to set up an Infrastructure network
between your two adapters, using the product Quick Install or Instruction Guides for
details when necessary.
The example above assumes a previously established wired network with Internet
sharing supplied via a router.
1. Connect your wireless access point to one of your router’s LAN ports using an
Ethernet cable. Use the access point’s instruction guide for installation details.
2. Install your wireless adapters, including their drivers and utility programs using
the instructions provided by the vendor.
3. From your configuration utility, make sure that your Network Type, SSID, Channel,
and Security Settings are all set to the same values for each device on your wireless
network. Also make sure that the IP addresses for each device are in the same range
as (but not identical to) each other and that the computers use the same subnet mask.
Note: You may be able to use your Wireless Access Point to configure these settings
on your wireless adapters. Check with your WAP’s documentation for details.