9
Destination setting:
• Destination IP Address:
The server IP Address and socket port
would be connected in TCP client and
UDP client mode for a certain server IP
Address.
• Destination socket port:
The server socket port would be
connected in TCP Client and UDP Client
mode for a certain serial port.
• Connection:
The connection can be selected in two modes, Auto or
Manual.
• Serial I/O setting:
Baud rate, parity, data bits, stop bits
Baud rate:
300 - 115200bps
Parity:
None, Even, Odd
Data Bits:
7,8
Stop Bit:
1 or 2
• Serial I/O Interface:
RS-232:
TxD, RxD for data stream, no flow
control
RS-232 (RTS/CTS):
TxD, RxD for data stream,
RTS/CTS for flow control
RS-232 (RTS/CTS, DTR/DSR):
TxD, RxD for
data stream, RTS/CTS for flow control. DTR
for socket status, DSR for socket open/close
control
RS-485 (Half duplex):
Half duplex RS-485
interface
RS-422 (Full duplex):
Full duplex RS-422
interface
• Packet mode of serial input:
Packet mode could be in enabled/
disabled mode. If packet mode is enabled,
the data input from UART will be deferred
until the input buffer is full, or NETRS2321E
