4
IDE HDD: Only the USB 2.0 interface is available for connecting
an IDE hard drive to the host computer. Plug the 40-pin IDE data
cable into the port labelled CN1 on the enclosure’s PCB board.
Plug the included 4-pin SP4 to LP4 power adapter cable into the J1
connector.
To mount the hard drive, place it into the holding tray and press the
5.
tabs on either side down to secure the drive in the enclosure.
Slide the hard drive holding mechanism into the external casing,
6.
ensuring that the release button on the rear panel returns to its
original, locked position.
Driver Installation
Windows
®
2000/XP/Vista, Mac OS
®
9.x/10.x, Linux Kernel
®
2.4.x +
No driver installation is required for these operating systems, as this
enclosure is natively supported, so the drivers are already installed.
Software Installation
The following steps outline the procedure to install the software
included with your drive enclosure in Windows.
CN5
CN6
J1
CN1
