Instruction Manual
3
3. Ensuring the computer is powered down, remove the slot cover from a 3.5” floppy
drive bay on the host computer.
4. Gently, slide HSB220SAT25B into the now vacant 3.5” floppy drive bay, threading the
connected cables through the opening, until the front panel of HSB220SAT25B is
flush with the computer case front panel.
5. Make sure the screw slots located on the side panels of HSB220SAT25B are
aligned with the screw holes provided by the computer drive bay, then secure
HSB220SAT25B to the computer drive bay using the provided screws.
6. Connect both of the LP4 connectors provided by the Y-cables (see steps #1, #4) to
LP4 connectors provided by the computer power supply.
7. Connect the remaining ends of the SATA Data cables to the appropriate ports on
the computer motherboard. You may want to make note of which SATA ports
are used on the motherboard, in relation to their location on the rear panel of
HSB220SAT25B.
Drive Installation
Once HSB220SAT25B has been secured within the computer casing, and connected
appropriately:
1. Open the front panel doors by gently sliding the locking button from left to right,
then gently pull the door outward (exposing the drive bay):
