10
E
N
10
2.1 Dimensions
Winch dimensions
Pattern measures
2.2 Winch performance
Line pull by layer
Wire layers
Line pull Kg
Cable capasity m
1
907
1.8
2
742
4
3
628
6.7
4
544
10
Performance of 1st layer
Line pull
Kg
Wire speed m/min
Current A
0
4.0
19
454
3.1
70
680
2.5
90
907
2.5
110
3 Winch installation
WARNING!
Do not begin the installation until you are sure that you have technically understood the manual and perform the
work
only in the order provided in this manual!
The manual must be available during all work performed on the system,
third parties included.
WARNING!
•
This is general instruction for the installation. Instructions may have to be applied due to the vehicle model. If you
are uncertain about the installation, Get the winch installed by a professional
•
Disconnect the battery cables before installing the winch!
•
Be sure the location will be strong enough to support the rated pulling force of the winch.
•
If the mounting bolts needed are different in length from that supplied, use a bolt of equal or better quality to that
supplied by the manufacturer.
1.
Install the mounting kits or prepare a flat and secure location on the vehicle for the winch
2. Position the winch over the mount and check for operation of the clutch lever to frame clearance. Check for tire to winch clearance.
3. Secure the winch to the mounting bracket or surface chosen with the correct hardware.
4.
Make sure the winch mounting bolts and the winch hardware has been tightened for proper torque.
3.1.1 Wiring instructions
Warning:
Only use a 12V automotive battery in good condition.
1.
Plan a route for the wiring from the point of the vehicle where the
winch will be mounted, or used, to the battery.
2.
If you drill through the bumper or any part of the body to route the
wires, be sure to install a rubber grommet in the hole to prevent
fraying of the wires at that point.
3.
Route cables from the solenoid (2) to the battery (4)
4.
Attach the wires from the solenoid to the terminals on the winch
5.
Attach the circuit breaker (Optional equipment) to the positive ter
-
minal on the battery(3).
6.
Attach the red battery cable to the circuit b)
7.
Attach the black cable forom the solenoid straight to the negative
terminal of the battery.
138mm
285,5mm
320mm
10
7.
5mm
58mm
107,5mm
48mm
74m
m
4
113mm
99mm
76mm
76mm
48mm
8mm
3
4
2
1
9201-10000-T
Содержание 9201-10000
Страница 28: ...28 R U 28 IN OUT 4 4 1 1 2 3 A 1 2 90 3 B 1 2 90 3 4 2 1 2 3 4 1 8 4 3 IN 5 5 1 5 2 9201 10000 T...
Страница 29: ...29 R U 29 6 1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8 7 9201 10000 T...
Страница 30: ......
Страница 31: ......
