Rapid Recovery™ Kinetic Winch Installation Instructions
Covers Part #6224 (Element RC)
Kit Contents:
●
35" x 1/8" Kinetic Shock Cord (1 Piece)
●
Stainless Steel Multi Hook (1 Piece)
●
Aluminum Pulley with Bearings (2 Pieces)
●
M3x10 Button Head Screws (2 Pieces)
●
M3x12 Button Head Screws (2 Pieces)
●
M3x16 Button Head Screws (5 Pieces)
●
M3 Flat Washers (2 Pieces)
●
M3 Shoulder Screw (1 Piece)
●
M2.5x8 Socket Head Screws (2 Pieces)
●
Element RC Mount Set (5 Pieces)
Attaching the Multi Hook to the Kinetic Cord
1. Put the loop end over the shoulder screw in the front
mount or on the chassis depending on your setup.
2. Route the cord through the chassis back around the
pulley then back up through the front rope guide or
fairlead. Mark 1” back from the rope guide and cut the
cord. Burn the cut end with a flame.
3. You can remove the cord off of the pulley for some
slack to make installing the hook easier and then route
the cord back through the rope guide before securing
the hook with a figure 8 knot as shown in the diagram
below.
