5
4
PostScript Picture
SENSORA1 [Converted] EPS
PostScript Picture
SENSORAL [Converted] EPS
PostScript Picture
SENSORA2 [Converted] EPS
Using 5/32" (4mm) hex wrench, adjust reel holder arm to vertical.
Place the label roll on the 1" (25mm) reel hanger bar.
*If roll has 3" (76.2mm) core, use plastic spool*
Slide Material Guide onto reel hanger bar to hold roll against reel holder arm to ensure it is
held straight.
(Hex wrench, Material Guide and spool included.)
Thread the liner under the guide rod, between the hold down pad and the strip plate, then
back under the strip plate. Lay the liner across the slot in the take-up hub. Slide the lock rod
into the slot to secure the liner. Align shaft guide on guide rod with edge of liner to keep
material feeding straight.
Hold Down Pad:
Using the upper thumbscrew on the side of the machine, adjust the hold down pad for
tensioning.
For best results, labels should be pressed firmly against the strip plate. If labels are held too
tightly, they will cause excessive drag on the motor.
Photosensor:
The photosensor can be adjusted in any direction to accommodate virtually any label.
Loosening the lower thumbscrew allows the photosensor to swivel and sets the overhang
distance of the label over the strip plate. When the label is being fed the correct distance,
tighten the lower thumbscrew.
Loosen the two screws on the front of the sensor holder to align the photosensor with the
center of the label. If there are two or more labels across, align the photosensor with the last
label to be removed. When these two screws are tightened, the machine is set.
Hold Down Pad
Photosensor
Strip Plate
Guide Rod
Lock Rod
Take-up Hub
Reel Hanger Bar
Reel Holder Arm
Incorrect
Correct
Sensor sees beyond label
- Will not stop
Sensor sees strip plate
- Will not feed
Sensor sees front edge of label
ADJUSTMENTS
SET-UP INSTRUCTIONS
Positioning of Photosensor
