Starrett W2900, Руководство пользователя

Страница: 6 / 118

6 PKG08863-UMW2900
GENERAL INFORMATION
1.1 Basic Operating Instructions
1. Turn on your tool, check the upper left of the display to see
if the battery symbol is showing. If the battery symbol is
showing (Fig.1A) then go to the “Rechargeable Battery Care and
Maintenance” section, on page 11. If there is no battery symbol
visible then the battery is charged.
2. Lightly clean the contact point.
3. Fasten the indicator into the appropriate holding device.
4. You can turn the indicator on by either pressing the ON/OFF
button or moving the spindle.
5. If applicable, pick the unit of measure, inch or millimeter by
pressing the IN/mm button. Note: standard metric indicators do
not have this function available.
6. Place the indicator perpendicular to the reference surface being
measured. Allow enough movement to be able to take a higher
or lower measurement. Note: This is one of many possible ways
to use the tool.
7. Zero Sequence: Zero the tool by pressing the ZERO Button. When
you press the ZERO button the display will show a dashed line
as seen in (Fig.1B). The dashed line will incrementally disappear
from left to right (Fig.1C); Make sure not to move the spindle
during this time. This is a visual reminder to wait for the tool to
zero out. This will happen each time the tool is zeroed, and takes
less than a second to complete.
8. Lift the spindle to remove the reference surface, and carefully
place the piece to be measured under the spindle making contact
with the surface. The value measured on the display will be the
difference between the reference and the measured piece.
9. The indicator can be turned off by pressing and holding the ON/
OFF button for 3 seconds.
Note: the unit will automatically enter sleep mode in 30 minutes, if left
unattended.
1.2 Button Descriptions and Functions
The functions printed in yellow; LIMITS and PRESET, are used in conjunction with
the SHIFT/SET button also printed in yellow. To enable these functions press the
SHIFT/SET button first. The SET (S) icon will appear in the top left corner, and then
press the button for the required function.
1 SHIFT/SET
Dual function button used to enable the, Preset and the
Limits function. When enabled the SET (S) icon will be
displayed on the top left corner of the display.
2
Wireless
Button
Press and hold for 2 seconds to turn ON/OFF the Wireless
function. A quick push sends a reading over the wireless
network. See “Section 3 Wireless Overview, pg.9”.
3
MIN/MAX/
TIR
Displays the minimum or maximum values captured
during the movement of the spindle while in the min/
max limits operation. The TIR function displays the
difference of the two readings. See “Setting the Min/Max/
TIR” on page 8.
4 +/-
Plus/Minus sets the direction (polarity) of the reading
5 IN/MM
Toggles the display between English or Metric units.
6 LIMITS
Press the SHIFT/SET button then press the LIMITS button
to enable the function. Refer to the section, “Setting the
Limits” on page 6.
7 ON/OFF
Power button. Press and release to turn on, and Press and
hold for 3 seconds to turn off.
8 ZERO
Press and release the ZERO button and the display will
zero. The spindle must not be moved until the Zero
Sequence has elapsed. See “Zero Sequence” on page 3,
instruction #7.
9 ABS
Enables the ABS mode. Press and hold for 2 seconds to
activate the ABS mode, Press and hold for 2 seconds to
exit the ABS mode.
10 PRESET
Press the SHIFT/SET button then press the PRESET button
to enable the PRESET function. Refer to the section
“Setting PRESETS” on page 5.