starrett.com • 978-249-3551
Form No. 953
09/09 Specifications subject to change.
Tolerance Mode
Used to set gage with upper and lower
measurement tolerances.
Setting Tolerances
Press and Hold
MODE
until TOL appears
To preset lower tolerance value:
Press and Release
MODE
To change digit value:
Press and Release
SET
To advance to next digit:
Press and Release
MODE
To store lower value and advance to upper
tolerance:
Press and Hold
MODE
until TOL appears
To change digit value:
Press and Release
SET
To advance to next digit:
Press and Release
MODE
To store upper value and return to
Tolerance Mode:
Press and Hold
MODE
until TOL appears
To exit Tolerance Setting Mode:
Press and Hold
MODE
MEASUREMENTS CAN NOW BE TAKEN
Measuring in Tolerance Mode
To enter TOLERANCE MODE:
Press and Hold
MODE
until TOL appears
MEASUREMENTS CAN NOW BE TAKEN
Hold
Used to hold a measurement value on the
display.
Note:
Hold function is not available when
in the Set Modes.
To Hold the reading:
Press and Release
SET
To release Hold:
Press and Release
SET
Data Transmission
This tool comes with an Opto-RS232 out-
put port (Fig. 1 [3]) that allows data trans-
mission thru a traditional wire to a variety
of peripherals or by connecting to a Star-
rett DataSure® Wireless Data Collection
System using a Cat.1500-3-1N end node.
The print command is controlled by the
SET button.
To send data transmission with the cable
or end node attached:
Press and Release
SET
Fig. 1
2
1
3
