3
Reference Mode
REF I and REF II Modes will allow for two
independent preset values to be set up.
(Ex. REF I = 0.0000 / Zero,
REF II = .74990 / Gage Master)
Entering a Preset Reference Value
Note:
The tool needs to be in the correct
REF Mode before the preset value of that
REF can be entered.
(To change See Reference Mode below)
Press and Hold
MODE
until REF I or II and
PRESET appears
To change digit value:
Press and Release
SET
To move cursor to right:
Press and Release
MODE
To store preset value:
Press and Hold
MODE
until REF I or REF II appears
MEASUREMENTS CAN NOW BE TAKEN
Measuring in Reference Mode
To enter Reference Mode:
Press and Hold
MODE
until REF I or REF II appears
To change between REF I and REF II:
Press and Release
MODE
To save tool in this mode:
Press and Hold
MODE
until REF I OR II appears
MEASUREMENTS CAN NOW BE TAKEN
RECALL PRESET REFERENCE VALUE
Used to calibrate the gage to a preset
value, provided REF I or REF II preset
values have been set (See Entering Preset
Reference Values). NOTE: The recalled
value depends on the REF MODE the tool
is in.
Press and Hold
MODE
until INCH/MM and
SET appears
Place the gage into the Gage Master
Press and Release
SET
To go back to the Measurement Mode:
Press and Hold
MODE
until REF I or II appears
MEASUREMENTS CAN NOW BE TAKEN
ZERO RECALL
Used to calibrate the gage to zero,
provided REF I or REF II preset value has
been set to .0000 / zero (see Entering
Preset Reference Values). NOTE: The
recalled value depends on the REF MODE
the tool is in.
To zero the display in Set Mode:
Press and Release
SET
To store Preset value:
Press and Hold
MODE
MIN / MAX Mode
Used to display Min and Max
measurement values on the gage
Note:
Min and Max displayed values are
based on the preset value of the REF
Mode which the tool is in when entering
the MIN / MAX Mode.
Measuring in MIN / MAX Mode
To enter MIN / MAX MODE:
Press and Hold
MODE
until MIN MAX and
SET appears
MEASUREMENTS CAN NOW BE TAKEN
To view Min Reading:
Press and Release
MODE
To clear previous measurement value:
Press and Release
SET
To view Max Reading:
Press and Release
MODE
To clear previous measurement value:
Press and Release
SET
To zero display in MIN MAX MODE:
Press and Release
SET
