Starret DataSure, Руководство оператора

Страница: 33 / 39

DataSure™ Operators Manual 33 PT 6*****
•
Appendix A: Application Interfaces
Virtual multiplexers within the
DataSure™
software are emulations of the Starrett 761A and
761B. Communications with other applications use the same 761 Command Set and RS232
protocol parameters:
9600
BAUD
8 DATA BITS
1 STOP BIT
NO PARITY
Command Syntax Default
Measure M nn<cr>
Sequence S nn,nn,nn,..nn<cr> or S -1<cr> 01
Report R<cr>
Auto A ON<cr> or A OFF<cr> OFF
Buzzer B ON<cr> or B OFF<cr> or B n OFF
Poll P nn OFF
Version V<cr>
Units U ON<cr> or U OFF<cr> ON
Port Number N ON<cr> or N OFF<cr> ON
Save SV<cr>
Note: Commands are not case sensitive.
<cr>
Is the syntax notation for pressing the Enter key (Carriage Return).
n
Is the syntax notation for a numeral value 0,1,2,3,4,5,6,7,8, or 9.
• Measure Command:
This command is used to get a reading from any one of the tools that are connected to the
multiplexer.
Example:
Transmitted Data Received Data
M 03<cr>
#03 00.7000 in
• Sequence Command:
This command is used to set up the sequence that will be used when the Auto mode is
turned ON. When a reading is displayed for the first port number of a sequence, a
reading will automatically be taken from the next port number, and continue in turn until
the sequence is complete. Polling the first port number of a sequence will cause the
string of sequential measurements to repeat.