Starport Cellphone Detector Plus 610, Руководство пользователя

Страница: 3 / 15

3
INTRODUCTION
Your Cellphone Detector Plus™ 610 is a versatile state-of-the-art
cellular phone detector. It senses the radio frequency (RF)
transmissions from nearby cellular or mobile phones. If required, other
sources of RF transmissions can also be detected including two-way
radios, and other wireless communication devices. When a transmission
is detected, an alarm sequence begins that may include any
combination of visual LED flash, beeps and voice alert message
requesting users to turn off their communication devices. In addition the
unit can be used as a static or portable detector, and it can be used to
generate remote alarms, activate other equipment (including jammers)
and extend alarm messages into other areas.
QUICK START
1) Attach AC power cord to the 9Vdc power socket on the underside of
the unit OR unscrew the REAR CASE SECTION to insert 4 C type
Alkaline batteries. Ensure polarity is correct. Then reattach the case.
2) Use both hands to remove the FRONT GRILLE PANEL (below left).
3) With a small flat screw driver gently check that the THRESH dial is
set to FAR (above centre). Caution: do not force this dial.
4) Locate the ON / OFF switch and click it to ON (above right).
5) Press the TEST / MUTE / REC button on the front of your Cellphone
Detector Plus™ 610 to test the alarm sequence.
6) Replace the front Grille Panel by gently sliding it back on until it snaps
into place.
Your Cellphone Detector Plus™ 610 is now operational.
Test
your unit by making a call on your cellphone at various distances.