The Transmitter button may be accessed by sliding the door on front of unit to expose button.
Antenna on unit may be extended.
Transmitter contains a small 12v alkaline battery.
Remove the three screws from the back and carefully separate the two halves, replace battery.
If the tiny screws wont tighten for you, add a little white glue to each hole, assemble and insert
screws. The white glue will harden around the threads.
Installation recommendations.
Photo1
shows the remote receiver sync button. In the event you should lose the remote or it stops
working, you can purchase another remote transmitter and resynchronize it to the receiver board.
When installing your light kits, make sure the receiver board is in an area you can access it in the
future.
You may also want to extend the antenna inside your kit, test your distance. I was able to activate
the effect 40 feet away through closed doors in the house, possibility more, but 40 was plenty for me.
Information below is for any future
replacement of remote.
Syncing new replacement unit:
To sync a new replacement unit, turn on the power to your kit, press and hold the small button on
the receiver until the light flashes , then press the button on the remote transmitter. It might take you
a couple of tries before they sync.
Press the transmitter button to test if it activates your effect. If not, start the process again.